/var/folders/yf/4dbjhxmx3xx657c5cbgdx0kc0000gn/T/com.microsoft.Word/WebArchiveCopyPasteTempFiles/SMdeBhmKE5uKD3K9NiiQMDCg8a1rFN4ZcA.png?1585168518

Our platform enables you to quickly and easily connect your data sources to SQL Server table. This enables a one-way synchronization to occur - where any changes in the SQL table are downloaded into your data source on a regular basis. Your data source will be automatically updated in this way until you remove the connector or an error occurs (such as losing authorization to access the database).


Before you add a SQL Connector, you must ensure that you have a valid SQL Server Connection set up on your organization.


To Set up a SQL Connector to your Data Source, follow these simple steps:

  • Go to Connected Data -> Data Sources


  • In the list of available data sources, hover your mouse over the listing of the data source you wish to connect.

  • A set of options will show; click on the settings link.

    /var/folders/yf/4dbjhxmx3xx657c5cbgdx0kc0000gn/T/com.microsoft.Word/WebArchiveCopyPasteTempFiles/sKNU_ebBqbIYdGQw9cgzIdX9WSGe28p-Ng.png?1585168332


  • On the Settings page, mid-way down you should see a Connector heading.

     

/var/folders/yf/4dbjhxmx3xx657c5cbgdx0kc0000gn/T/com.microsoft.Word/WebArchiveCopyPasteTempFiles/RWTBHLYBVkEgSdsavahTmfbyZOk6kDhRVg.png?1585168332

  • Click /var/folders/yf/4dbjhxmx3xx657c5cbgdx0kc0000gn/T/com.microsoft.Word/WebArchiveCopyPasteTempFiles/InmvuIA4UTht8BA4Vv-6ExRa7Tea9fiPBg.png?1585168332
  • A new window will appear with the selection of connectors to choose from.


The page should refresh with your newly added connector.


/var/folders/yf/4dbjhxmx3xx657c5cbgdx0kc0000gn/T/com.microsoft.Word/WebArchiveCopyPasteTempFiles/7-D28KP5KBCul6lRQ46-Hq4dSNUXYovC3A.png?1585168332


Next, configure the following:

  1. Table Name: The SQL Server database table from which rows will be retrieved.
  2. Ignore Internal Columns: If enabled, this connector will ignore all columns where the column name starts with an underscore (e.g., _lastupdated). If your table has a column named _identity and internal columns are not ignored, this column will always be the first column of the data source. Other internal columns are added to the end. 
  3. Refresh Frequency: The frequency that data is pulled by this connector.


When you save your changes, the connector will be fired for the first time and will subsequently run at the interval specified in the connector settings. Wait a minute or so and then check the Rows page for your data source. If rows are not downloaded, then there may be an error with the connection to the SQL Server. You can check this by clicking on the View Logs button shown next to your connector on the Settings page.